1 2011-10-03 22:20:25 CONNECTED TO: FIAT STILO 1.6 16V SIEMENS MY 99 Airbag (2F-2P-2L-2T-I-C) SIMULATION MODE!!! -------------------------------------------------------------- Kod ISO: 26 86 9B 02 9E Numer rysunku FIAT: 00 51 71 18 16 Wersja SW: 0.7 Wersja HW: 1.4 Data zaprogramowania: 01-01-2003 READING ERROR CODES: 1: 3C - Czujnik uderzenia czolowego No help available at present Powodem tego błędu jest Zakucenia wykryte / Wadliwy sygnał Obecny status błędu jest Przerywany Błąd wartość licznika jest 8 2: 0E - Ladunek wybuch. airbag boczny ze str. kierowcy The ECU detected a short to Ground or Battery + in the Side Airbag Squib circuit(s) as indicated by the code. ATTENTION! TURN THE KEY OFF FOR AT LEAST 10 MINUTES, THEN DISCONNECT THE BATTERY AND WAIT FOR 15 MINUTES, THEN DISCONNECT THE AIRBAGS. After disconnecting the Airbags, inspect the wiring for the short, and replace the harness if faulty. NOTE: In some cases the code may refer to both driver and passenger side Squib circuits, or to a defect in the ECU itself. After completing the test and replacing the faulty parts, assemble the system and reconnect the battery as the last step. After that, read the codes and data again to ensure the system to be OK Powodem tego błędu jest Wartość zbyt wysoka Obecny status błędu jest Przerywany Błąd wartość licznika jest 147 3: 0E - Ladunek wybuch. airbag boczny ze str. kierowcy The ECU detected a short to Ground or Battery + in the Side Airbag Squib circuit(s) as indicated by the code. ATTENTION! TURN THE KEY OFF FOR AT LEAST 10 MINUTES, THEN DISCONNECT THE BATTERY AND WAIT FOR 15 MINUTES, THEN DISCONNECT THE AIRBAGS. After disconnecting the Airbags, inspect the wiring for the short, and replace the harness if faulty. NOTE: In some cases the code may refer to both driver and passenger side Squib circuits, or to a defect in the ECU itself. After completing the test and replacing the faulty parts, assemble the system and reconnect the battery as the last step. After that, read the codes and data again to ensure the system to be OK Powodem tego błędu jest Otwarty obwód Obecny status błędu jest Przerywany / Obecny(ciagły) Błąd wartość licznika jest 170 4: 02 - Zasilanie Centralki The code is set when the ECU Supply Voltage is out of the specified range longer than allowed. Certain system clear this code at the next start after the voltage is OK. Check the ECU supply circuit and ECU ground. Check also: - Alternator, diode pattern, battery, pole and cable condition, good ground connections between alternator, engine, chassis and battery negative pole. Powodem tego błędu jest wartość zbyt niska Obecny status błędu jest Przerywany Błąd wartość licznika jest 160 EXECUTING ACTUATOR... Lampka awaryjna Kompletne
rysiek21008